Magic Chef MCSCD6W1 Manual Del Usuario página 25

PROBLEM POSSIBLE CAUSES
Not enough detergent
was dispensed.
Items are blocking the
rotation path of the
The dishes water spray arm.
are not
The filter assembly at
clean.
the base of the unit is
not clean, is clogged,
or is not installed
correctly. This may clog
the spray arm jets.
Cloudiness This is a combination
on the of soft water and too
glassware. much detergent.
Black or gray Aluminum utensils
marks on have rubbed against
dishware. the dishes.
Dishware blocked the
Detergent
detergent cups,
left inside
preventing them to
the dispens-
open fully during the
er cups.
wash cycle.
Improper loading of
dishware.
Too little rinse aid.
Dishes were removed
from the washer too
The dishes
soon.
are not dry.
Wrong wash cycle
sequence
selected.
Using cutlery with a
low quality
coating.
POSSIBLE SOLUTION
Use more detergent, or change the type of detergent being
used by the dishwasher.
Rearrange the items accordingly so that the spray arm can
rotate freely.
Clean and properly secure the filter into its seat and fit the
filter assembly correctly into the unit. Clean the spray arm
jets. See the "Care and Maintenance" section of this manual.
Use less detergent if you have soft water, and select a
shorter wash cycle sequence to clean the glassware.
Use a mild abrasive cleaner to remove the marks.
Rearrange the dishes accordingly and rerun the wash cycle
sequence.
See "Loading Dishwasher" section of the user manual.
Increase the amount of rinse aid dispensed or refill the
rinse aid dispenser if empty.
Do not empty your dishwasher immediately after the cycle
ends. Open the door slightly, so that the steam can escape.
Begin unloading the dishwasher once the dishes are barely
warm to the touch.
Shorter wash cycle sequences use lower temperatures with
lower cleaning performance capabilities. Choose a wash
cycle with a longer wash time to resolve this issue.
Water drainage is more difficult with these items.
Cutlery or dishes of this type are not suitable for
dishwasher use.
25