Tabla de contenido
Publicidad
ENGLISH
•
Do not twist or kink the cable, or wrap it round the appliance.
•
This appliance is not intended for commercial or salon use.
PARTS
1. On/off switch
2. Head and cutter assembly
3. Comfort Float cutters
4. Hairpocket
5. Charging indicator light and low battery
indicator (XR1430)
6. Fuel gauge (XR1450)
7. LED display (XR1470)
GETTING STARTED
It is recommended that you use your new shaver daily for up to four weeks to allow time for
your beard and skin to become accustomed to the new shaving system.
CHARGING STAND
•
Rotate open the charge stand fully to stand firmly on a flat surface while charging. For
travel you can fold the stand around the shaver.
CHARGING YOUR SHAVER
•
Ensure the appliance is turned off.
•
Connect the charging stand to the adaptor and then to the mains.
•
Place the shaver in the charging stand.
•
Charge for at least 24 hours when using for the first time.
•
Allow 90 minutes for a full charge (XR1450 and XR1470) and 4 hours for XR1430.
•
The charging indicator light (XR1430), fuel gauge (XR1450) or LCD display(XR1470) will
indicate when the shaver is fully charged.
•
XR1430: When charge is low, the top LED will illuminate a solid red light. When
charging the bottom LED will illuminate a solid green light. When fully charged both
LEDs will be off.
•
XR1450: The fuel gauge will display the amount of charge left when the shaver is on.
When charging, the LEDs blink in a clockwise rotation. When fully charged all LEDs will
illuminate then turn off.
•
XR1470: When charge is low 'Lo' will appear on the screen and will flash until the shaver
is plugged in to charge. When charging, the LEDs blink in a clockwise rotation. When
fully charged the indicator will flash 60 for 5 minutes and then the display will shut off.
•
To preserve the life of your batteries, let them run out every 6 months then recharge
for 24 hours.
•
The appliance adapts automatically to a mains voltage between 100V and 240V.
4
8. Pop-up trimmer
9. Trimmer release button
10. Charging pins
11. Charging stand
12. Adaptor (not shown)
13. Headguard (not shown)
14. Cleaning brush (not shown)
Publicidad
Tabla de contenido
