Remington Stylist HC363C Manual Del Usuario página 4

ENGLISH
C GETTING STARTED
, CHARGING YOUR APPLIANCE
• Before using your hairclipper for the first time, charge for 14-16 hours.
• Ensure the product is switched off.
• Connect the charging adaptor to the product and then to the mains.
• The charging indicator will illuminate.
• Your clipper cannot be overcharged. However, if the product is not going to
be used for an extended period of time (2-3 months), unplug it from the mains
and store.
• Fully recharge your hairclipper when you would like to use it again.
• To preserve the life of your batteries, let them run out every 6 months then
recharge for 14-16 hours.
, CORDED USE
• Connect the charging adaptor to the product then to the mains.
• Extended mains only use will result in the reduction of the battery life.
F INSTRUCTIONS FOR USE
, Before starting the cut
• Inspect the clipper making sure that it is free from hair and dirt.
• Seat the person so that their head is approximately at your eye level.
• Before cutting, always comb the hair so it is tangle free and dry.
, TO ATTACH A COMB
• Hold the comb with its teeth upward.
• Slide it onto and along the clipper blade until the front of the comb firmly sits
against the clipper blade.
• Gently push the back of the comb down so it snaps into place.
, TO REMOVE THE COMB
• Holding the clipper with the blades facing away from you firmly push the
comb on the back tab upward and away from the blades
• Each comb attachment is marked accordingly on its outside middle surface.
• (3mm, 7mm, 9mm, 12mm, 18mm, 25mm, left and right ear guide).
• Replacement combs available. Model: SP254
4