Battery Removal - Remington XF8505 Manual De Instrucciones

ENGLISH
• Pulling: as the cutters wear, your shave may not feel as close and you may feel
the cutter pulling your hair.
• Wear through: you may notice that the cutters have worn through the foils.
, TO REPLACE THE FOIL
• Remove the foil assembly by pressing the foil assembly release buttons on
either side of the head and lifting the assembly upwards to remove from the
hair pocket.
• Insert the new foil assembly on the hair pocket, press down and click into
place.
, REPLACING THE CUTTERS
• Grasp the cutter between your thumb and forefinger and pull upwards.
• Snap the new cutter into the oscillator tip.
, Note: DO NOT press on the cutter ends as this may cause damage.
• Foil head replacements can be found on the Remington website.
Spare part number SPF-XF05
E TROUBLESHOOTING
• If your shaver battery is completely empty or the shaver has not been used
for an extended period of time, the shaver may not start when operated
using the cord. If this occurs, a 5 minute quick charge will allow for 3 minutes
of shaving.

BATTERY REMOVAL

• The battery must be removed from the appliance before it is scrapped.
• The appliance must be disconnected from the supply mains when removing
the battery.
• Slide the trimmer up to the open position and remove a single philips head
screw.
• Using a small flat screwdriver pry the back cover off the shaver.
• Using a philips screwdriver remove 8 screws to open the back of the internal
housing.
• Remove and open the core from the shaver to expose the batteries.
• Cut the wire connecting the batteries to the circuit board and remove the
batteries.
• The battery is to be disposed of safely.
6