Kohler 1900A Serie Guia De Instalacion página 8

Roller
Top Track
Roller
Screw
Roller
Groove
Bottom
Track
Bottom Track Slot
7. Install the Moving Panels
With the top of the moving panel angled away from you, insert the rollers into the roller groove of
the top track. Slide the bottom of the moving panel into the bottom track slot.
Slide the moving panel back to the open position.
Repeat the above procedure to install the other moving panel.
Place both moving panels into the closed position.
Verify both moving panels interlock at the corner.
NOTE: If necessary, the moving panels may be adjusted one at a time. To adjust, loosen the roller screws
and tilt the panel to achieve a smooth fit. Retighten the roller screws. Adjust the other moving panel, if
necessary.
8. Install the Bumpers
From the top of the wall frame, measure and mark 4" (10.2 cm) down and 3/4" (2 cm) in.
From the bottom of the wall frame, measure and mark 4" (10.2 cm) up and 3/4" (2 cm) in.
Remove the paper backing from the rubber bumpers.
Affix the center of the rubber bumpers onto the marked positions on each wall frame.
1034044-2-B
Shower
Moving
Panel
3/4"
(1.9 cm)
4"
(10.2 cm)
Wall Frame
Bumper
(Bottom)
4"
(10.2 cm)
8
Bumper
(Top)
Wall Frame
3/4" (1.9 cm)
Sterling