Kohler 1900A Serie Guia De Instalacion página 5

Wall Jamb Lip
Hole
Location
Groove
2. Install the Adjustment Blocks
Lay both wall jambs down on a flat surface with the lip facing up.
Slide an adjustment block into each end of the channel of each wall jamb.
Position each adjustment block over the hole on each end of the wall jamb between each of the
location grooves.
Using the blade of a flat-blade screwdriver, tap the wall jamb lip down onto the edges of the
adjustment blocks. This will secure the adjustment blocks in place.
Place the tip of a Phillips screwdriver into the hole of the top adjustment block. Using your thumb
and forefinger, turn the adjustment blocks counterclockwise until the adjustment blocks are flush
against the wall jamb. Do not turn the adjustment blocks past flush.
Repeat this procedure for the second wall jamb.
3. Install the Wall Jambs
Align the holes of the wall jamb with the drilled holes in the wall.
Secure the wall jamb with #8-18 x 1-1/4" panhead screws.
Repeat this procedure for the second wall jamb.
Sterling
Screwdriver
Adjustment
Block
Screwdriver
Adjustment
Block
Wall Jamb
5
Wall
Mounting
Screw
#8-18 x 1-1/4"
Panhead
Screw
Shower
Wall
Jamb
1034044-2-B