Four-Component Universal Remote
Congratulations on your purchase of this four-component
universal remote . Your universal remote controls up to
four electronic components and makes juggling remote
controls a thing of the past . You can program your
RCA brand universal remote to operate most models of
most brands of infrared, remote-controlled components
manufactured after 1990 . (See the enclosed Code Lists for
a complete list of brands .) And, not only is your remote
easy to program, it's easy to operate, too . We've specially
designed this remote with big buttons to give you total
control...at the touch of your fingertips.
!
TIP:
programmed to operate most RCA, GE and PROSCAN
branded TVs, DVD players and satellite receivers . Just
press the corresponding key—VCR for a VCR player;
DVD for a DVD player; TV for a television; SAT·CBL for a
satellite receiver or a cable box .
Battery Installation
and Information
Your universal remote requires two AAA Alkaline
batteries (batteries may or may not be included,
depending on model) . To install the batteries:
Note: Reprogramming may be required after batteries
are replaced .
Battery Precautions:
• Do not mix old and new batteries .
• Do not mix alkaline, standard (carbon-zinc) or
rechargable (nickel-cadmium) batteries .
• Always remove old, weak or worn-out batteries
promptly and recycle or dispose of them in
accordance with Local and National Regulations .
Battery Saver
Your universal remote control saves battery power
by automatically turning off if any key is pressed for
more than 60 seconds . This saves your batteries should
your remote get stuck in a place where the keys remain
depressed, such as between sofa cushions .
CR450_NA_IB_02.indd 3
The four-component universal remote is already
1 . Remove the battery
2 . Insert the batteries, matching the
3 . Press and push the battery cover
compartment cover .
batteries to the (+) and (-) marks
inside the battery compartment .
back into place .
1/30/07 1:01:26 PM