Yamaha NS-PA40 Manual De Instrucciones página 5

1
Base
1
Bottom
(Front side)
Base
Bottom
(Front side)
2
Bottom
(Front side)
2
1
Front
Top
(Front
side)
2
Front
Bottom
(Front
side)
Approx. 15 mm (5/8")
3
Base
Projection
Base
This notch
must face in
the same
direction as
the rear panel.
Base
Bottom
(Front side)
Rear
Rear
Top
Bottom
Approx.
12 rotations
Assembling the front speakers
1
Attach the Base to the Bottom.
1 Insert the three projections on the Base into the
three holes on the lower end surface of the
Bottom. Make sure that the notch on the Base
faces in the same direction as the rear panel of
the Bottom, which includes a groove for a
speaker cable.
2 Insert four screws (included in the package)
from the underside of the Base to affix the base
to the Bottom. First finger-tighten each screw
alternately, then tighten them all securely.
Hint
As shown in the illustration, you can use the
packing polystyrene foam to support the Bottom.
Bottom
Invert the Bottom and
insert it into this opening.
2
Attach the Top to the Bottom.
1 Place the assembled Bottom and Base on the
floor as shown in the figure.
Place the Top on the Bottom so that the Top will
sit slightly toward the front (by approx. 15 mm
(5/8")).
2 Slide the Top slowly toward the rear until it
stops and the rear panel of the Top aligns with
the rear of the Bottom.
3 Attach the Bottom to the Top by using a Phillips
screw driver to securely tighten the supplied
screws. Rotate approximately twelve times
clockwise.
Top part of packing
polystyrene foam
2
En