Publicidad
Idiomas disponibles
Idiomas disponibles
Caution: Use of controls or adjustments or performance of procedures other than those specified herein
may result in hazardous radiation exposure.
Caution: The use of optical instruments with this product will increase eye hazard.
Setup - Before Use:
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual inclu-
ding all text under subheadings therein before set up or use of this product.
WARNING
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off and unplug the tool from its electrical outlet before performing any
procedure in this section. Note: For additional information regarding the parts listed in the following
pages, refer to the Assembly Diagram.
Assembly
1. Insert the ends of the Table Extensions into the holes in the sides of the Base. Tighten the Wing Screws
to hold the Extensions in place. The upper edge of the Extensions will be level with the surface of the saw.
This provides a wider base for the work material to rest on.
2. Thread the Miter Knob into the end of the table above the Miter Lock until securely in place.
3. Slip the Dust Collection Bag over the Dust Outlet behind the saw.
Mounting
Use the four bolt holes provided in the Base to mount the Miter Saw to a stable support before use.
Mounting hardware not included.
7
www.ELITETOOLS.co
Keep Working
Publicidad
