Publicidad
Idiomas disponibles
Idiomas disponibles
6. Remove the Spindle Bolt* (64) and Flange (65), see Figure B. *IMPORTANT: The Spindle Bolt has
a left-handed thread and removes by turning CLOCKWISE.
Note: Make sure the other Flange (65) stays in place on the Spindle.
7. Remove the Blade (66) and install the new Blade. Make sure that the Blade's rotation arrow
points in the same direction as the rotation arrow on the Upper Guard (43).
8. Replace the Flange and Spindle Bolt. Position the cupped side of the Flange against the blade. Hold
in the Spindle Lock (90) and wrench tighten the Spindle Bolt by turning it COUNTERCLOCKWISE.
Release the Spindle Lock.
9. Rotate the Guard Pivot Plate (61) back into place, and secure it with the Guard Pivot Bolt (63).
10.
WARNING! Make sure the Lower Guard (56) operates smoothly and properly protects from the
Blade before using the saw.
Using the Workpiece Extension Supports
1. The Table Extensions are inserted into each side of the Table, and locked in place using the Wing
Screws.
11
www.ELITETOOLS.co
Keep Working
Publicidad
