Publicidad
Idiomas disponibles
Idiomas disponibles
Calibrating the Miter Table Indicator
After checking or adjusting the fence to confirm that it is at 90º to the Blade, check the accuracy of the Miter Table
Angle Indicator.
1. Loosen the screw holding the Angle Indicator in place.
2. Rotate it until the pointer is exactly on 90º.
3. Retighten the screw.
Calibrating the Bevel Angle
For making accurate cuts, the Saw Blade must be adjusted to be exactly vertical to the Table.
1. To check the angle, have the blade assembly in its normal upright position. Make a cut on a
piece of flat sided, fairly thick scrap material.
2. Check the cut with an accurate square. The cut should be at exactly 90º.
3. Angle can also be checked by rotating one cut-off piece 180º and holding the cut ends together.
If the cut is not exactly vertical, the two pieces will form a slight angle.
4. If necessary, the bevel angle can be corrected by adjusting the Bevel Adjustment Screw on the right side
under the Bevel Locking Lever.
5. Once the bevel angle is adjusted, adjust the Bevel Angle Indicator to read 0º when the Saw Blade is in the
vertical position. Loosen the screw holding the Indicator in place, adjust it to be exactly over the 0º mark, then
retighten the screw.
Adjusting or Replacing the Kerf Board
If the Kerf Board becomes damaged it must be replaced.
1. Remove the four screws holding the Kerf Board in place.
2. Install a new Kerf Board. Replace the four screws and tighten them slightly.
To adjust the Kerf Board:
1. Lower the Saw Blade and lock it down with the Locking Pin.
2. Adjust the Kerf Board so the right side of the Blade slightly clears the edge of the Kerf Board.
3. Loosen the Bevel Lock and set the Bevel Angle at 45º left.
4. Ensure that the left side of the Blade clears the Kerf Board.
5. Tighten the four screws holding the Kerf Board in place.
17
www.ELITETOOLS.co
Keep Working
Publicidad
