Storage; Anomalies-Causes-Solutions - PYD Electrobombas XKS Serie Manual De Instalación Y Mantenimiento

OPERATING AND MAINTENANCE MANUAL
SERIE XKS

4. STORAGE

Storage: Clean and store the pump in a frosf-free place before the first frost arrives.
Disposal: The product must not be added to normal household waste. It must be dispo-
sed of in line with local environmental regulations.
The following cleaning and maintenance work in chapter 6 must be repaired by manu-
facturer, its service agent or qualified person.

5. ANOMALIES-CAUSES-SOLUTIONS

Risk of injury due to electric shock. Do not carry out the pump working on. Disconnect
the pump from the mains before cleaning the suction base and feed impeller.
Anomalies Causes
The pump 1. Power not switched on.
won´t start. 2. The float switch is not
connected to the circuit.
The pump 1. Air locks in the suction
won't base.
discharge. 2. Feed impeller clogged.
3. The discharge pipe is
stuck
The pump 1. The float switch is
won´t start. blocked in the upper part.
The flow 1. The intake filter is
rate is clogged.
inadequate. 2. Pumping flow rate
falls because the pump
is clogged with water
impurities.
The pump 1. Dirty partides are
stops after jammed in the suction
working for a base.
shot time. 2. The heat protector
stops the pump due to
overheating.
3. The heat protector
stops the pump due to
clogging.
If you have any problems with your pump, please contact our Service.
www.proindecsa.com / proindecsa@proindecsa.com
Solutions
1. Check the mains voltage.
2. Lift the float.
1. Wail for Max.1 minute until air escapes
through the vent bores automatically.
Switch off and on in turn if necessary.
2. Disconnect plug and clean feed impeller.
3.Release the pipe.
1. Release the float and reposition the
pump.
1. Clean the filter.
2. Clean tha pump and its environment.
1. Pull out the plug and clean the pump and
sump.
2. Make sure the water temperature does
not exceed 35°C.
3. Clean the pump.
8