RISCO Group Beyond Wireless DT Instrucciones De Instalación página 10

Detector Configuration
Being bi-directional, the detectors parameters can be modified from the keypad or from the system
configuration software according to your needs.
PIR Sensitivity:
MW Sensititvity
Anti-Mask
Supervision Time:
LED:
Operation Mode:
Disposition Sensor:
* Default
** In maximum sensitivity sway recognition is disabled to achieve optimum sensitivity
NOTE: The Disposition Sensor sends an alarm following change in the position of the detector.
Camera Detector Configuration via RISCO Configuration

Software
Configure the camera settings through the RISCO Configuration Software (right-click on the Serial
Code field in the Zones node screen and in the displayed pop-up click Additional..) or through the
panel quick key programming sequence as follows (default in bold):
Programming > 2) Radio Devices > 2) Modification > 1) Zone [Select (1–32)] > 1) Parameters > 6)
Advanced 5) Camera Parameters:
Images at Alarm:
Image Interval:
Pre-Alarm Image: Yes (Yes, No) (Image capture upon each arm)
Image Resolution: QVGA (QVGA 320X240 or VGA 640X480)
Image Quality:
Color Image:

Applicable to RWX350DC model
High/Low*
Min. 25%, 50%, 65%*, 85%, max. **
Yes/No*
0-255 minutes (15 min*)
On*/Off
Walk Test: The detector transmits after each detection
Normal*
Enable/Disable*
3 (1 to 7 images)
0.5 sec (0.5, 1, 2 seconds)
High (High, Low)
Color (Color or B&W)
10