How To Charge; How To Clean; Technical Data - Adler europe AD 2923 Manual De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 10
17. Do not allow the device or power adaptor to wet. If the device falls into water,
immediately remove the power plug or power adaptor from the socket. If the device is
powered, do not put hands in the water. Have the device checked by the qualified
electrician before using it again.
18. Do not touch the device or power adaptor with wet hands.
19. The device has to be turned off after every use.
20. In order to provide additional protection, it is recommended to install residue current
device (RCD) in the power circuit, with residual current rating not more than 30 mA. Contact
professional electrician in this matter.
21. If the device utilises a power adaptor, do not cover it, because this can cause a
dangerous temperature rise and can damage the device. Always connect the power
adaptor cable to the device, and then connect the power adaptor to the power socket.
22. Do not press on foil.
23. Do not attempt to try foil open.
24. Do not charge the shaver when temperature is above 35 C or is lower than 5 C.
DESCRIPTION OF THE DEVICE (PIC. 1)
(1) - on/off switch
(2) - head with shaving foil
(3) - charging indicator light

HOW TO CHARGE

Before first use:
1. Plug one end of the DC Adaptor into the shaver and the other end to an electrical outlet 5V 1A.
2. The red indicator light (3) will light to indicate the unit is charging.
3. Unplug the DC Adaptor from the unit and the electrical outlet before using.
4. Shaver can be used for approximately 7 days on a single charge.
DO NOT CHARGE FOR MORE THAN 20 CONSECUTIVE HOURS
HOW TO USE
1. Remove the protective blade cover and push the thumb switch up the "ON" position
2. Begin shaving in the opposite direction of hair growth.
3. To achieve a closer shave, pull skin taut with one hand while shaving with the other.
4. After shaving, turn unit to the: OFF" position and replace the protective blade cover.

HOW TO CLEAN

1. First remove the protective blade cover.
2. Next press the two buttons located on the either side of the top of the shaver to release the foil
3. Using the cleaning brush provided, gently clean the foil and the cutter
4. May also be cleaned with water weekly
5. After cleaning, replace the foil and the protective blade cutter.

TECHNICAL DATA:

Power: 2W
Charging: 5V 1A
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding
waste bins. Used appliance should be delivered to the dedicated collecting points due to hazarsous
components, which may effect the environment. Do not dispose this appliance in the common waste bin.
(4) - foil release button
(5) - power socket
DEUTSCH
DEUTSCH
4
o
o

Publicidad

Tabla de contenido
loading

Tabla de contenido