Controls And Their Functions - Yamaha NS-SW500 Manual De Instrucciones

2
Front
panel
3
4 5
7 8
!
#
Rear panel

CONTROLS AND THEIR FUNCTIONS

1 Indicator
1
Green: The subwoofer is turned on.
Red: The Automatic power-switching function
has activated, and the subwoofer is in
standby mode.
Off: The subwoofer is turned off.
Top panel
2 Port
Outputs super-bass sound.
3 OUTPUT (TO SPEAKERS) terminals ( page 3)
Can be used for connecting to the main speakers.
Signals from the INPUT1 terminals are sent to these
terminals.
4 INPUT2 (NORMAL) terminals ( page 3)
Used to input line level signals from the amplifier.
5 INPUT3 (LFE) terminals ( page 3)
6
The HIGH CUT control ! has no effect on the signals
input to these terminals.
6 SYSTEM CONNECTOR jack ( page 5)
Connect the supplied system control cable here. If you
use the system control cable to connect a subwoofer to
a Yamaha component (that features a system connector
9
)
jack), turning on or off the power to the connected
component automatically turns the subwoofer on or
off.
7 INPUT1 (FROM AMPLIFIER) terminals
( page 4)
Used to connect the subwoofer with the speaker
terminals of the amplifier.
@
8 AUTO STANDBY (HIGH/LOW/OFF) switch
( page 5)
This switch is originally set to the OFF position. By
setting this switch to the HIGH or LOW position, the
subwoofer's automatic power-switching function
operates. If you do not need this function, leave this
switch in the OFF position.
Note
Be sure to set the POWER switch to OFF before you set
the AUTO STANDBY switch.
9 PHASE switch ( page 6)
This switch is to be set to the REV (reverse) position.
However, depending on your speaker system or listening
conditions, there may be a case when better sound quality
is obtained by setting this switch to the NORM (normal)
position. Select the best position by ear.
) B.A.S.S. (Bass Action Selector System) switch
( page 6)
When this switch is set to
MUSIC, the bass sound in
audio software is well
reproduced. When the switch is set to MOVIE, the bass
sound in video software is well reproduced.
! HIGH CUT control ( page 6)
Adjusts the high frequency cut off point.
Frequencies higher than
the frequency selected by
* One graduation
this control are all cut off
of this control
(and not output).
represents 10 Hz.
@ VOLUME control
Adjusts the volume level. Turn the control clockwise to
increase the volume, and counterclockwise to decrease
the volume.
# POWER switch
During normal usage, set this switch to ON. If you plan
not to use the subwoofer for a long period of time, set the
switch to OFF.
2
En