Connecting The Ac Power Cable - Conceptronic CB100S24S Guía De Instalación Rápida

ENGLISH
Warning: Installing systems in a rack without the front and side stabilizers installed could cause the rack
to tip over, potentially resulting in bodily injury under certain circumstances. Therefore,
always install the stabilizers before installing components in the rack. After installing
components in a rack, do not pull more than one component out of the rack on its slide
assemblies at one time. The weight of more than one extended component could cause the
rack to tip over and may result in injury.

3.3 Connecting the AC power cable

Plug one end of the AC power cable into the power connector of the switch and the other end into a free
wall outlet.
After the switch is powered on, the LED indicators will momentarily blink. This blinking of the LED
indicators represents a reset of the system.
Note: In the event of a power failure, unplug the switch. When power has resumed, plug the switch
back in.
13