How To Operate Your Ceiling Fan; Important - Fanimation TWOFOLD LP8551LBN Manual Del Usuario

How to Assemble Your Light Kit or Cap (Continued)
5A. (Option A--for use with light kit)
Connect the 2 single pin connectors from the LED
assembly to the 2 single pin connectors from motor
assembly. (Figure 5A)
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circuit to the fan before installing
your light kit.
5B. (Option B--for use with steel cap)
If you want to install the steel cap and not the light kit.
Assemble the steel cap to the light kit by twisting in a
clockwise direction. (Figure 5B)
NOTE: If you have installed your fan with the steel
cap, skip Steps 6 and 7.
6. Assemble the LED assembly to the light kit using
the two key slots. Replace the removed screw from
Step 3 and secure all three screws. (Figure 6)
CAUTION
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
7. Secure the glass to light kit by twisting in a
clockwise direction. Twist the glass gradually
snaps onto the light kit.
(Figure 7)
1. IMPORTANT: Using a full range dimmer switch (not
included) to control fan speed will damage the fan. To
reduce the risk of fire or electrical shock, do not use a
full range dimmer switch to control the fan speed.
(Figure 1)
Do not over-tighten.

How to Operate Your Ceiling Fan

Figure 5A
Light Kit
LED Assembly
Light Kit
until it
14
Light Kit
LED
Assembly
Figure 6
Figure 7
For illustrative purposes only-not
intended to cover all types of controls
Figure 1
Steel Cap
Figure 5B
Glass