Installing The Cutwork Needles; About The Cutwork Needles; Installing The Needle Plate Spacer - Baby Lock BNCW Guia De Instalacion

INSTALLING THE CUTWORK NEEDLES

About the Cutwork Needles

The four cutwork needles (multi-needle machine
needles No. 1 through No. 4 with blades in
different orientations) can be installed to cut fabric
automatically.
Each needle has a blade at a different fixed angle.
The machine uses the needle at the angle
appropriate for the orientation of the cutting line.
Be sure to install the needles at their specified
positions.
1 2
1
The needle is marked with a specific number,
depending on the blade angle. Install the
needle so that this number is in the same
position as the machine's needle bar number.
2
The needle is marked with a specific color,
depending on the blade angle. This, together
with the needle number, allows the cutwork
needle type to be identified.
3
Each needle has a blade at a different angle
(in 45° increments), and the machine cuts the
fabric with the blade at the angle appropriate
for the orientation of the cutting line.
Note
• The machine will automatically change
needles when cutting around a desired
shape.
The following specific information appears on the
cutwork needle.
Needle bar number
4
on the machine
4
Needle number
Orange
Color
Angle
Note
• Do not use the cutwork needles with
machines incompatible with the cutwork
functions.
3
3 2 1
3 2 1
Green Purple Blue
INSTALLING THE CUTWORK NEEDLES
Installing the Needle Plate
Spacer
1 1
Installing the spacer prevents the fabric that is
being cut out from getting caught in the machine's
needle plate while creating cutwork. Before
installing a cutwork needle, install the spacer.
Memo
• Once the needle plate spacer has been
installed, leave it installed. With the spacer
still installed, you can continue to perform all
embroidering functions including cutwork.
a
Turn off the embroidery machine.
b
Remove the needle plate, and then open the
hook cover.
a Needle plate
b Hook cover
15