Optional Accessories; Installing The Cutwork Embroidery Upgrade For Multi-Needle Machines; Installation Procedure; [Step 1]Obtaining The Certification Key - Baby Lock BNCW Guia De Instalacion

INSTALLING THE CUTWORK EMBROIDERY UPGRADE FOR MULTI-NEEDLE MACHINES

Optional Accessories

The following are available as optional accessories to be purchased separately.
1.
INSTALLING THE CUTWORK EMBROIDERY
UPGRADE FOR MULTI-NEEDLE MACHINES
Before Installation
This section describes how to upgrade your machine.
A single upgrade kit will only upgrade one machine.
In order to enable the cutwork functions, the Certification Key must be entered in the certification screen.
Use the KIT CW Certification Key Issuing Wizard on the CD-ROM (for machines) to obtain the Certification Key.
If the machine upgrade is canceled before it is completed or if the procedures are not performed as described,
the upgrade will not be installed completely.
Do not remove the CD-ROM from the CD-ROM drive of the computer while the Certification Key Issuing
Wizard is activated. Remove the CD-ROM after the upgrade is completed.
Before beginning the installation, check that the computer meets the system requirements.
System Requirements
Operation System
CD-ROM drive
Others

Installation Procedure

For installation, procedures must be performed using both your computer and on your machine. In this
Installation Guide, operations performed from the machine will be indicated with
and operations performed from the computer will be indicated with
[Step 1] Obtaining the Certification Key (page 7)
[Step 2] Upgrading the Machine (page 9)
[Step 3] Certifying the Upgrade (page 12)
[Step 4] Switching to Cutwork Mode (page 14)
Note
• If you have any questions, visit your authorized Baby Lock retailer.
6
Part Name
Table
When arranging multiple copies of a single pattern to make all cuts at one time, we recommend
using the table sold separately in order to ensure a smooth flow of the fabric.
®
Windows XP, Windows Vista
Required for installation
Internet connection available and one available USB port (required to upgrade the
embroidery machine) when using computer
Part Code
Description
ENTABLE
® ®
, Windows 7 (32 or 64 bit)
before the step.
before the step,