Worx WG751 Manual Del Usuario página 16

MAINTENANCE
WARNING: Stop the mower and remove
the safety key before removing the grass
collection bag.
NOTE: To ensure long and reliable service, perform
the following maintenance procedures regularly. Check
for obvious defects such as a loose, dislodged or a
damaged blade, loose fittings, and worn or damaged
components. Check that the covers and guards are
all undamaged and are correctly attached to mower.
Carry out any necessary maintenance or repairs before
operating mower. If the mower should happen to fail
despite regular maintenance, please call our customer
helpline for advice.
BLADE SHARPENING
KEEP BLADE SHARP FOR BEST MOWER
PERFORMANCE. A DULL BLADE DOES NOT CUT
GRASS CLEANLY OR MULCH PROPERLY.
WEAR PROPER EYE PROTECTION WHILE
REMOVING, SHARPENING, AND INSTALLING
BLADE. ENSURE THAT SAFETY KEY IS REMOVED.
Sharpening the blade twice during a mowing season
is usually sufficient under normal circumstances.
Sand causes the blade to dull quickly. If your lawn
has sandy soil, more frequent sharpening may be
required.
REPLACE BENT OR DAMAGED BLADE
IMMEDIATELY.
WHEN SHARPENING THE BLADE (See Fig. N)
16
1. Make sure blade remains balanced.
2. Sharpen blade at the original cutting angle.
3. Sharpen cutting edges on both ends of blade to
keep it balanced, removing equal amounts of
material from both ends.
NOTE:
1. Be sure the mower is turned off and remove the
key.
2. Place the mower in stand up storage mode.
BLADE BALANCING (See Fig. O)
Check balance of blade by placing center hole in
blade O-1 over a nail or screwdriver shank O-2,
clamped horizontally in a vise O-3. If either end of
the blade rotates downward, file that end. Blade is
properly balanced when neither end drops.
BLADE MAINTENANCE (See Fig. P1, P2)
Replace your metal Blade after 50 hours mowing
or 2 years, which ever is the sooner-regardless of
condition.
Follow these procedures to remove and replace the
Blade. You will need garden gloves (not provided)
and a spanner wrench (not provided) to remove the
Blade. Hold the Blade and unscrew the Blade Bolt
counter-clockwise using a spanner wrench, and then
remove the Blade.
To re-assemble, position the Blade with the cutting
edges towards the ground. Then securely tighten the
Blade Bolt.
3-in-1 Cordless Lawn Mower
STORAGE (SEE FIG. M1,
M2)
Stop the mower and always remove the Safety Key.
Clean the exterior of the machine thoroughly using
a soft brush and cloth. Do not use water, solvents or
polishes. Remove all grass and debris, especially from
the ventilation slots.
Turn the machine on its side and clean the blade area. If
grass cuttings are compacted in the blade area, remove
with a wooden or plastic implement.
Store the machine in a dry place. Do not place other
objects on top of the machine.
To aid storage, release the Handle knobs, and rotate or
fold the Upper Handle.
FOR BATTERY TOOLS
The ambient temperature range for the use and storage
of tool and battery is 0 C-45
o
The recommended ambient temperature range for the
charging system during charging is 0
104 F).
o
C (32 F-113 F).
o o o
C-40 C (32 F-
o o o
EN