Progress Lighting AirPro P250008 Instrucciones De Instalación página 8

Close-to-Ceiling
Mounting
1. Remove the canopy ring from the canopy
by turning the ring to the right until it locks.
(Figure 5)
2. Remove the mounting plate from the canopy
by loosening the four screws on top of the
canopy. Remove the two non-slotted screws
and loosen the slotted screws. This will
enable you to remove the mounting plate.
(Figure 6)
3. Remove the decorative canopy bottom cover
from the canopy by depressing the three
studs. (Figure 8)
4. Remove three of the six screws and lock
washers (every other one) securing the
motor collar to the top of the fan-motor
assembly. (Figure 9)
5. Route the wires exiting the top of the fan-
motor assembly through the rubber gasket
aligning the holes in the rubber gasket with
the three screw holes in the fan-motor
assembly.
6. Route the wires exiting the top of the fan-
motor assembly through the canopy ring,
and the canopy (make sure the slot openings
for the canopy ring and canopy are on top).
Place the canopy over the collar at the top of
the motor. (Figure 10)
5.
7. Align the mounting holes in the canopy
with the screw holes in the motor and fasten
using the three screws and lock washers
(removed previously). Tighten the mounting
screws securely.
Motor
Collar
Figure 8
Screw and
Lockwasher
(3 of 6 places)
Figure 9
Figure 10