To Stop The Product; To Start The Product - Husqvarna 525LS Mark II Manual De Usuario

2. Move the choke control up into choke position.
WARNING:
starts to rotate immediately when you
start the engine with the choke.

To start the product

WARNING:
instructions in the safety chapter before you
start the product (refer to
1. Use protective gloves.
2. Hold the body of the product on the ground with your
left hand.
CAUTION:
3. Hold the starter rope handle with your right hand.
4. Slowly pull out the starter rope with your right hand
until you feel some resistance (the starter pawls
grip).
WARNING:
rope around your hand.
5. Pull the cord quickly and with power.
CAUTION:
rope all the way out and do not let go off
the starter rope handle when the starter
rope is fully extended. This can cause
damage to the product.
6. Pull the starter rope until the engine starts or for a
maximum of 5 times.
7. Reset the choke when the engine starts or after you
pull the starter rope 5 times.
8. If it is necessary, pull the starter rope again and
again until the engine starts.
9. Let the engine run for 10 seconds.
14
The cutting attachment
Read the warning
Safety on page 4 ).
Do not use your feet!
Do not twist the starter
Do not pull the starter
10. Operate the throttle gradually.
11. Make sure the engine runs smoothly.
Note:
If the engine stops, do the procedure again.

To stop the product

1. Move the stop switch into the stop position to stop
the engine.
CAUTION:
automatically goes back to its initial
position. In order to prevent accidental
starting, the spark plug cap must be
removed from the spark plug when
assembling, checking and/or
maintenance is done.
About the surface
WARNING:
is identified with gray in the illustration.
There is a risk of burn injuries when the
product is hot. There is a risk of electrical
shock if the spark plug cap is damaged. Do
not use a product that has a damaged spark
plug cap.
The stop switch
Do not touch the area that
1560 - 002 - 22.06.2021