Rack Installation - Yakima LowRider MAX Manual De Instrucciones

RACK INSTALLATION

Push end caps onto
the ends of the
crossbars.
ON THE CAR'S ROOF:
Set the towers
and bars onto
your car's racks.
Position towers equally
from front of car.
1033347A-3/15
• Make sure the wedge is
inside the tower and
flush with the face.
• The claw should be as
far back as possible.
DO NOT INSTALL
TOWER directly over
factory crossbar.
ON A LEVEL SURFACE:
SLIDE TWO TOWERS ONTO
EACH CROSSBAR while
keeping the wedges in place.
Be careful to keep the bars horizontal; the loose
towers could slide from the bar and fall.
Keep the pads
from curling at the
sides when
positioning the
towers.
You may need to move the factory crossbar if
there is any interference with the towers.