JUNO ICPL426EN-DB120 Instrucciones De Instalación

JUNO TYPE ICPL426EN-DB120, ICPL426E, ICPL426EN,
ICPL418E & ICPL413E NEW CONSTRUCTION
RECESSED HOUSING
WARNING: For your safety, read and understand instructions completely before starting installation.
Before wiring to power supply, turn off electricity at the fuse or circuit breaker box.
NOTE: Juno recessed fixtures are designed to meet the latest nec requirements and are listed in full compliance
with ul 1598. Before attempting installation of any recessed lighting fixture, check your local electrical building code.
this code sets the wiring standards and installation requirements for your locality and should be understood before
starting work. use of non-Juno trims voids Juno warranty. Ballast is replaceable from below ceiling by a qualified
electrician.
SAVE THESE INSTRUCTIONS
TYPE IC FOR
INSULATED CEILINGS
Figure 1
Juno type icpl fixtures are designed for direct
contact with insulating materials which are
approved for this application (Fig. 1). Fixture
has thermally protected ballast and mechanical
protection to prevent the misuse of lamps.
Fixtures may also be used in non-insulated
ceilings.
Juno air-loc housings are supplied with
pre-installed gaskets for energy savings and
to comply with washington state and other
energy codes.
1300 south wolf road • des plaines, il 60018 • phone 800-323-5068 • www.junolightinggroup.com
INSTALLATION INSTRUCTIONS
Hg Hg
INSTALLATION INTO
JOIST CONSTRUCTION
Figure 2
Step 1. extend bar hangers to fit between
joists. Bar hanger foot is contoured to easily
align with bottom of joist (Fig. 2). position
fixture by hammering real-nails
®
(Fig. 3).
(Note: Bar hanger may be shortened to fit 12"
framing or smaller by breaking at score lines).
Step 2. slide fixture along bar hangers into
desired location. use locking screws or slot to
secure (Fig. 4).
Relocating Fixture – nail can be removed
with hammer claw to allow easy repositioning
of fixture without damaging bar hanger or nail
(Fig. 5).
Step 3. Follow steps 1-4 under electrical
connection.
Step 4. when installing in drywall, cut 4 1/2"
diameter hole.
Mark Means laMp contains Mercury.
Follow disposal laws.
see www.laMprecycle.org
Figure 3
into joists
Figure 4
Figure 5
© 2010 Juno lighting llc rev 4/10 p2862 pg 1 of 2