Publicidad
Idiomas disponibles
Idiomas disponibles
JUNO TYPE ICPL426EN-DB120, ICPL426E, ICPL426EN,
ICPL418E & ICPL413E NEW CONSTRUCTION
RECESSED HOUSING
INSTALLATION INTO
SUSPENDED CEILING
Figure 6
Step 1. locate center of proposed opening on
ceiling tile and cut 4 1/2" diameter hole.
Step 2. place ceiling tile in t-bar grid.
Step 3. place fixture into position and snap bar
hanger foot with integral t-bar clips onto t-bars
(Fig. 6). additional holes provided for securing
with wire or screws (Fig. 7).
Step 4. Follow steps 1-4 under electrical
connection.
Figure 7
INSTALLATION INSTRUCTIONS
ELECTRICAL CONNECTION
INSTRUCTIONS
non-Metallic
cable
Metal
conduit
Figure 8
Step 1. provide electrical service according to
your local electrical code to the wiring box
located on the plaster frame. supply wire
insulation must be rated for at least 90°c.
Step 2. remove wiring box cover. remove the
appropriate knock-out(s) to accommodate the
type of electrical service to be used/allowed by
your local electrical code (Fig. 8):
Metal Conduit. remove appropriate round
knock-out(s) and connect conduit to wiring box
with proper connectors (not supplied).
Non-Metallic Cable. remove appropriate
knock-out(s) from top of wiring box and insert
cable, pushing it past the cable grip. no other
connector is required.
Step 3. Standard J-Box: connect supply
wires to fixture wires with proper wire nuts (not
supplied), so as to cover all bare current-
carrying conductors.
J-Box with Quick Connectors: strip supply
wire 3/8", insert each supply wire into
appropriate junction box connector. connect
black fixture wire to hot, white fixture wire to
neutral and green fixture wire to ground.
Step 4. place all wiring and connectors back in
wiring box and replace cover.
TRIM INSTALLATION
after ceiling is finished and painted, remove
trim gasket from inner housing (Fig. 9). install
gasket on the trim if one is not already provided
with trim. to install trim into fixture:
Step 1. remove inner housing from fixture.
Step 2. install proper compact fluorescent lamp
as listed on housing label.
Step 3. install trim with gasket into inner
housing until firmly seated with no gap between
trim and inner housing.
Step 4. insert inner housing assembly, with trim
and gasket installed, into the fixture
Housing
inner
Housing
gasket
trim
Figure 9
© 2010 Juno lighting llc
rev 4/10
compact
Fluorescent
lamp
p2862
pg 2 of 2
Publicidad
