Handling The Remote Control - GE MGI09CAB3 Manual De Uso Y Cuidado

Handling the remote controller
Location of the remote controller.
• Use the remote control within a distance of
8 meters from the appliance, pointing it to-
wards the receiver. Reception is confirmed
by a beep.
• The air conditioner will not operate if cur-
tains, doors or other objects block the sig-
nal from the remote control to the indoor
unit.
• Prevent any liquid from falling into the re-
mote control. Do not expose the remote
control to direct sunlight or heat.
• If the infrared signal receiver on the indoor
unit is exposed to direct sunlight, the air
conditioner may not operate properly. Use
curtains to prevent the sunlight from falling
on the receiver.
• If other electrical appliances react to the
remote control, either move these appli-
ances or consult your local dealer.
• Do not drop the remote control. Handle it
with care.
• Do not place heavy objects on the remote
control, or step on it.
8 m
90
Using the remote control holder (sold sepa-
rately)
• The remote control can be attached to a
wall or pillar by using a remote control
holder (sold separately).
• Before installing the remote control holder,
make sure that the air conditioner receives
the signals properly.
• Install the remote control holder with two
screws.
• Before installing or removing the remote
control holder, move it up or down in the
holder.
Replacing the remote control batteries
The following cases indicate exhausted bat-
teries. Always replace old batteries with new
ones.
• Receiving beep is not emitted when a sig-
nal is transmitted.
• Indicator fades away.
The remote control is powered by two dry
batteries (R03/LR03X2) housed in the lower
back of the unit and protected by a cover.
1. Remove the cover at the rear part of the
remote control.