Indoor Unit Installation - GE MGI09CAB3 Manual De Uso Y Cuidado

Indoor Unit Installation

PRIOR TO INSTALLATION
Refer to the label on the product box to make
sure that the model number of the indoor
unit matches the model number of the out-
door unit.
Step 1: Select installation location
Before installing the indoor unit, you must
choose an appropriate location. The follow-
ing are factors that will help you choose an
appropriate location for the unit.
A proper installation location will meet the
following conditions:
• Good air circulation.
• Convenient drainage.
• Noise from the unit will not disturb other
people.
• Firm and solid place, the location will not
vibrate.
• Strong enough place to support the
weight of the unit.
• A proper location will be at least one
meter from other electrical devices (e.g.,
TV, radio, computer, etc.)
98
DO NOT install the unit on the following loca-
tions:
• Near any source of heat, steam, or com-
bustible gas.
• Near flammable items such as curtains or
clothing.
• Near any obstacle that might block air
circulation.
• Near the doorway
• In a location subject to direct sunlight.
NOTE ABOUT WALL HOLE:
If there is no fixed refrigerant piping: While
choosing a location, be aware that you
should leave ample room for a wall hole (see
the drill wall hole for connective piping step)
for the signal cable and refrigerant piping
that connect the indoor and outdoor units.
The default position for all piping is the right
side of the indoor unit (while facing the unit).
However, the unit can accommodate piping
to both the left and right.