Technical Data; Use Of Extension Cords - Hilti DWS 225 Manual Del Usuario

• Do not use backing pads with a nominal working speed lower than 8000 rpm.
3.4 LED indicators on the control panel
On the control panel there is a multi-purpose LED to indicate operating status or malfunction of the power
tool, and an LED array for indicating speed (rpm).
Status
A: Multi-purpose LED shows green
B: Multi-purpose LED shows green
C: Multi-purpose LED flashes green/red
D: Multi-purpose LED shows red
D: Multi-purpose LED quick-flashes green/red
3.5 Sanding head 3
The sanding head is 180° flexible, enabling the operator to reach the surface to be sanded from different
angles. The power tool can track the operator's movements, so the operator can adopt an ergonomic
working position.
3.6 Items supplied
Random orbital sander, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
4

Technical data

For rated voltage, rated current, frequency and/or input power, refer to the country-specific type
identification plate.
If the device is powered by a generator or transformer, the generator or transformer's power output must be
at least twice the rated input power shown on the rating plate of the device. The operating voltage of the
transformer or generator must always be within +5 % and -15 % of the rated voltage of the device.
Weight in accordance with EPTA procedure 01
Speed
Eccentric stroke
Diameter, backing pad
5

Use of extension cords

Using extension cords
WARNING
A damaged supply cord presents a hazard! Do not touch the supply cord or extension cord if damaged
while working. Disconnect the supply cord plug from the power outlet.
▶ Check the appliance's supply cord at regular intervals and have it replaced by a qualified specialist if
found to be damaged.
• Use only extension cords of a type approved for the application and with conductors of adequate gauge
(cross section). The power tool may otherwise suffer a drop in performance and the extension cord may
overheat.
• Check the extension cord for damage at regular intervals.
• Replace damaged extension cords.
*2301587*
2
Meaning
AC supply connected.
Power tool switched on and/or start/stop button
pressed, speed indicator active.
Speed is increased/reduced; selected speed is
indicated by the LEDs.
Overtemperature warning.
Voltage outside appropriate range.
2301587
DWS 225
3.5 kg
4,000 /min ... 8,000 /min
(66.7 Hz ... 133.3 Hz)
5 mm
225 mm
English 5