Publicidad
Idiomas disponibles
Idiomas disponibles
CRADLES HAVE A FRONT AND BACK.
The smooth
depression on
right front side
must face
TOWARD you.
INSERT CABLE INTO MAST.
The tabs on the locking cap
should nest into the holes in
the mast end.
SECURE THE CRADLES TO THE MAST.
Insert the bolt and washer
(right to left) into the
rounded depression on the
underside of the cradle.
ATTACH CRADLE
STRAPS.
Be sure strap is
hooked onto cradle.
Your product includes a
stop-rivet.
Flex cradles and push over
stop-rivet on mast.
LOCKING CAP POSITION:
Compress the tabs to
install the locking cap.
Attach nut.
Use a flathead screwdriver.
POSITIONING THE CRADLES: You may want to adjust the
cradles once the bikes are loaded.
LOAD YOUR BIKE.
Nest bike's top
tube into first
cradle.
Make sure the open
part of the locking
cap faces down.
TIGHTEN EACH CRADLE
CAREFULLY.
Cradle with
YAKIMA logo
should go on
last, with
"YAKIMA"
facing out.
POSITION END CRADLE.
INSTALL LOCK PIN AND "E" CLIP.
Maneuver the pin into the hole,
bypassing the internal cable.
Load bikes in opposite
directions.
You may want to loosen
cradles and adjust bike spacing.
Don't forget to tighten
the bolts again!
Move the outside
cradle completely
forward until it
stops at the metal
rivet.
Publicidad
