Yakima SweetRoll Manual De Instrucciones página 2

PREPARE TO
INSTALL SADDLES
ONTO FRONT
CROSSBAR.
Attach two SnapArounds
per saddle.
SnapAround pairs must face
opposite directions on crossbar.
INSTALL ROLLERS ONTO REAR
CROSSBAR.
Attach two snaparounds
for each set of rollers.
SnapArounds should
open toward rear of
vehicle.
Insert two bolts
per roller.
Place the pads
onto the curved
surface of the
Push the rivets into the
saddles.
pads, and saddles.
The "Y" of YAKIMA
must sit at the tall end
of the saddle.
BE POSITIONED AS IN
LAST STEP.
BOLTS MUST BE
LOCATED TO THE REAR
OF VEHICLE.
INSERT SNAP ATTACH
RIVETS. SADDLES.
Insert bolts through
saddle's base and
into SnapArounds.
THE PADS MUST
ATTACH HEX
KEYS.
BRAKE TABS ON ROLLERS MUST FACE
OUTBOARD FROM VEHICLE.
Attach hex keys and
tighten COMPLETELY.
INSTALL AS SHOWN:
• Short Bolt
• Washer
• Lock Washer
• Wing Nut
Do not tighten yet.*
* The saddle height
will need to be adjusted
after your boat is loaded.
NOTE:
15"(38cm) is an
average distance
15" / 38cm
and will need to
be adjusted to
your boat's hull.
Release brakes on
rollers by pulling and
turning to the left.