Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Position boat hull onto rollers, and
slide boat into the front saddles.
If possible, allow one or both of the
bulkheads to sit on the mounts.
Holding the buckle end:
• Pass a strap over the boat, and
• Under each crossbar.
SET YOUR
ROLLER BRAKES!
Pull tab out and to the
right rocking boat
gently until the brake
tabs nest.
ROLLER NOTE:
You may need to loosen hex keys and
slide rollers inboard or outboard so
that rollers rest against the hull.
NOTE:
Always pass the
strap inboard to
the tower
TEST MOVEMENT BY ROCKING BOAT.
Tighten again if loose.
SADDLE NOTE:
You may need to loosen hex keys and
slide saddles inboard or outboard.
If necessary, adjust saddle height.
Push buckle clamp OPEN so that strap end
can pass through buckle.
BEFORE DRIVING AWAY:
Tighten straps and hex keys.
Tie down boat at front and rear.
PULL DOWN HARD
on strap end to
tighten.
Publicidad
Tabla de contenido
