Eaton LUMARK AXCL6ARL Instrucciones De Instalación página 5

6. Push wires into junction box and install cover plate (with
luminaire attached) to the junction box.
7 . Loosen the knuckle center screw. Adjust the position of
the fixture. Re-tighten.
1/4-20 Screws
Torque to 25 in-lbs
Knuckle
Figure 9. Axcent Small
Pole Mount
Tools Required
#2 Phillips head screwdriver, socket wrench, ¾" socket, ¾"
wrench, torque wrench.
1. The fixture comes with a wall mount wedge plate
pre-installed. Remove the wall mount wedge plate and
discard. (Figure 1.)
2. The pole mount arm is designed for a square or round
pole. Round pole installation will require the break-away
tabs to be removed. Use pliers to remove tabs.
(Figure 10.)
3. Using provided 1/2" hardware, secure the pole mount
arm to pole. Torque bolts to 40 ft-lbs. (Figure 11.)
4. Attach the quick-connect adapter to the fixture, pulling
the luminaire supply leads through the wedge plate
center hole. Tighten the (2) ¼-20 lock screws on the
fixture to 20 in-lbs. (Figure 12.)
Wedge Plate
1/4-20 Lock Screws
Torque to 20 in-lbs.
Installation Instructions – Axcent (Small & Large)
For Round Pole
Installations,
Break away Tabs
Figure 10.
Split Washer
Washer
1/2" Bolt
Washer
Figure 11.
Wedge Plate
Quick Connect
Arm Adaptor
Pole
Figure 12.
EATON
IB514031EN
9/16" (14.3mm)
Diameter Hole and Slot
7/8"
(22mm) 4-7/8"
(124mm)
Max
1/2" Nut
1/4-20 Lock Screws
Arm
Installation instructions
5