Yakima ROC n' Gate Manual De Instrucciones página 2

ATTACH BASE TO HITCH.
The hole in the hitch
must align to the
hole in the carrier.
Tighten QuickHitch bolt
using attached red
wrench.
TO REMOVE ROC CARRIER:
Remove Hitch Lock.
Loosen QuickHitch
bolt a turn or two,
using the red wrench.
1032398A-2/20
INSTALL QUICK HITCH
Insert QuickHitch bolt from right to left.
ATTACH HITCH LOCK.
QuickHitch
stays on
vehicle
while ROC is
in use!
Continue loosening by
compressing spring
with wrench while,
turning black knob
counter-clockwise.
THREAD QUICKHITCH BOLT.
Thread bolt by compressing spring with
attached red wrench, while turning black
knob clockwise.
TURN KNOB
UNTIL SNUG
LOCK CARRIER TO VEHCILE.
Insert key. Lock hitch lock.
Periodically
lubricate bolt
with a non-
water based
lubricant.