Yakima ROC n' Gate Manual De Instrucciones página 4

INSTALL CRADLE ASSEMBLY'S.
NOTE: Tabs on stabilizer arms
should be snapped to cradle.
INSERT CABLE INTO MAST.
Tabs on locking cap
should nest into holes
in mast end.
POSITION END CRADLE.
Move outside cradle and
stabilizer forward until cradle
rests against stop-button.
(Stabilizer arm slides over
stop-button).
1032398A-4/20
Push cradle assembly onto
mast and over stop-button, by
FIRMLY FLEXING
CRADLE UPWARD.
Compress tabs to
install locking cap.
INSTALL LOCK PIN
AND "E" CLIP.
Maneuver pin into hole,
bypassing internal cable.
LOCKING CAP POSITION:
Make sure the open
part of locking cap
faces down.