Yakima ROC n' Gate Manual De Instrucciones página 3

SLIDE MAST ASSEMBLY
ONTO ARM.
Hole in arm must align
with hole in mast.
TIGHTEN PIVOT BOLT.
Use adjustable-end
wrenches or 3/4"
wrenches.
Turn wrench until tight,
then loosen nut, 1/4 turn.
ATTACH RATTLER STRAPS
Slide ratcheted end of strap,
ratchets facing out, through slots
on cradle.
Pull firmly and wiggle
to bypass bumps.
1032398A-3/20
INSTALL PIVOT BOLT.
Wiggle mast to align holes.
Insert bolt and washer.
Secure with nut.
SECURE GATE.
There should be an audible "click"
as gate snaps into base.
ATTACH STRAP PADS
Slide wide end of strap
pad onto Rattler Straps.
Grooves in strap pad face
down towards cradle.
Tighten large wing nut.