Yakima HookUp Plus 2 Manual De Instrucciones página 2

REMOVE BASE CAP FROM
HOOKUP CARRIER.
Keep the cap in a safe
place for future use.
SECURE WITH
"PLUS 2" BOLT.
INSERT bolt and washer
from RIGHT TO LEFT.
TIGHTEN with
7/8" wrench.
SECURE WITH HARDWARE.
ROTATE PIVOT ARM CLEAR OF SUPPORT TRAY.
To release hook,
press the red trigger
on the handle.
1033312A-2/12
Pry the cap from
the base of the
HookUp carrier
with a flat tool.
SECURE bolt
with safety
clip.
Insert bolt, washer,
and nut, in order
shown.
Tighten with hex
wrench (included)
and 17 mm wrench.
Slide the hook down enough to
clear the rear wheel cradle.
INSERT BASE INTO
INSTALLED HOOKUP.
The holes in the bases
must align to each other.
ATTACH FIRST TRAY TO BASE.
Align holes in tray to holes in base.
FIRST TRAY:
Wheel strap is to your
right, and pivot arm
faces you.
ATTACH SECOND TRAY TO BASE.
• Attach second tray in opposite direction.
• Install tray with the pivot arm facing towards you.
• Secure with hardware.
• Rotate pivot arm
to other side of
support tray.
• Extend hook to
end of arm.
wheel strap
pivot arm