Troubleshooting - Easy Home S570 Manual Del Usuaria

Robotic Vacuum
Replacement of Battery
Remember to turn the power switch to the OFF position on bottom of vacuum before
taking out the battery.
Using a philips head screwdriver remove the 4 screws holding the battery door in place.
Open the door and take out the battery. (See Fig. 9) Plug new battery into connector on
base and screw the door back into place. (See Fig. 10)
Figure 9
WARNING
Don't place the battery in a high-temperature environment above 1130F
1.
(450C) or in water.
Don't forget to take out the battery if discarding the vacuum.
2.
The battery should be recycled safely. Don't discard it freely or throw it
3.
into a fire due to the possibility of explosion.
10
service@801service.net
Operation and Maintenance
Figure 10
AFTER SALES SUPPORT
1 866 558 8096
Robotic Vacuum

Troubleshooting

Problem
The Vacuum doesn't
work or cleans poorly
The Vacuum does not
charge automatically
The Vacuum is louder
then normal
AFTER SALES SUPPORT
1 866 558 8096
Troubleshooting
Solution
Check whether switch on bottom of
1.
vacuum is in ON position.
Check whether the dustbin, filter and
2.
intake are clean.
Check whether the charging adaptor is
1.
connected properly.
Check if the LED buttons are flashing.
2.
Clean the dustbin and filter.
1.
Check whether the brush or side brush is
2.
dirty or stuck.
service@801service.net
11