Publicidad
Idiomas disponibles
Idiomas disponibles
PUSH BASE ONTO
CARRIER MAST.
TIGHTEN with adjustable-end
wrenches or 9/16" wrenches.
WARNING:
DO NOT
OVER-TIGHTEN
THIS BOLT!
LARGE BOLT AND
LOCK-WASHER.
Use a 7/8 or 15/16 inch
socket wrench and
TIGHTEN.
ALIGN HOLES IN MAST AND BASE.
At center hole near end: Insert bolt and
washer. Attach another washer and nut
to bolt.
Insert pin into
holes in plates
and through mast.
LOCK THE
HITCH LOCK
CARRIER TO
SECURES THE
THE VEHCILE.
BOLT.
Insert the key, lock
the hitch lock.
Close the lock cap.
TIGHTEN with
adjustable-end
wrenches or 9/16"
wrenches.
INSTALL HITCH NUT AND
Secure wire onto
ATTACH THE CARRIER.
end of hitch pin.
Slide the nut
housing into the end
of the carrier.
CRADLES HAVE
A FRONT AND BACK.
cradles onto the mast
by flexing the cradle
upward.
Push the metal button to
allow installation.
Insert second bolt with a
washer into adjacent hole.
Position clear sleeve so bolt
can pass through.
Attach washer
and nut.
Insert the
carrier into
the hitch.
The hole in the hitch
must align to the hole
in the carrier.
The smooth depression on
the right front side must
face TOWARD you.
Push the
The cradle with Yakima
should go on last, with the
Yakima facing out.
Publicidad
