Publicidad
Idiomas disponibles
Idiomas disponibles
INSERT CABLE INTO MAST.
The tabs on the locking cap should nest
into the holes in the mast end.
LOCKING CAP
POSITION:
Make sure the open
part of the locking
Compress the tabs to
cap faces down.
install the locking cap.
INSTALL LOCK PIN AND
"E" CLIP.
Maneuver the pin into the hole,
bypassing the internal cable.
Load bikes in opposite
directions.
You may want to loosen the
cradles and adjust bike
spacing.
Don't forget to tighten the
bolts again!
Move the outside cradle
completely forward until it
stops at the metal button.
ATTACH CRADLE STRAPS.
Be sure strap is hooked onto cradle.
HOOK STRAPS OVER THE
BIKE'S TUBE.
Be sure the straps are
secured onto cradle hooks.
Straps can be routed
between the cables
POSITION END CRADLE.
Attach nut.
Use a flathead screwdriver.
POSITIONING THE CRADLES: You may want to adjust the
cradles once the bikes are loaded.
ATTACH STABILIZING BAR.
TIGHTEN.
Use an adjusable wrench.
CHECK THE CRADLES!
Grab close to the bar
with both hands.
TIGHTEN IF THERE IS
MOVEMENT.
and the tube.
SECURE THE CRADLES TO THE MAST.
Insert the bolt and washer (right to
left) into the rounded depression on
the underside of the cradle.
TIGHTEN EACH CRADLE
LOAD YOUR BIKE!
Secure with
Nest the bike's top tube into the
washers, nuts and
first cradle.
bolts.
LOCK YOUR BIKES TO THE
CARRIER.
Attach the cable-lock over the bike tube
and onto the pin in the mast.
NOTE: With last bike locked,
all other bikes are secure.
CAREFULLY.
LOCK IT.
Publicidad
