Troubleshooting - FAAC TM ER Serie Guia De Inicio Rapido

6
RESET RESTORES THE MOTOR'S FACTORY CONFIGURATION. THIS CAN BE CARRIED OUT AT ANY TIME, EVEN DURING THE SET-UP
PROCEDURE.
1) Press the programming key twice for 2 seconds
2) Within 2 seconds, press the programming key again for 7 seconds
3) The motor will rotate briefly in both directions to confirm memorisation
Each pression
2 seconds
P
x 2
7 TOTAL DELETION OF THE RECEIVER (the travel limits stay memorised)
SHOULD ALL THE MEMORISED REMOTE CONTROLS FAIL OR BE LOST, BEFORE IMPLEMENTING A NEW REMOTE CONTROL, IT IS
NECESSARY TO TOTALLY DELETE THE RECEIVER BUILT INTO THE MOTOR. THEN PERFORM THE MEMORISATION PROCEDURE OF THE
FIRST REMOTE CONTROL. THE SET TRAVEL LIMITS WILL NOT BE DELETED.
1) Cut off power to the motor, wait 10 seconds and connect the black wire with the brown one.
(If it features a "step-by-step" push-button, it is enough to keep it pressed without making the
connection).
2) Power the motor after about 10 seconds. The motor will turn in both directions for 1 second
indicating that the memory has been totally deleted.
3) Cut off power to the motor again. Disconnect the black (or red) and brown wire. (Release the "step-by-step"
push-button, if used)
8
PROBLEM
WHEN POWERED ON, THE MOTOR DOES
NOT MOVE
THE MOTOR ALREADY HAS SET TRAVEL
LIMITS BUT DOES NOT ACCEPT THE REMOTE
CONTROL COMMANDS
CANNOT COMPLETE THE TRAVEL LIMIT
LEARNING PROCEDURE
MOTOR WITHOUT SET TRAVEL LIMITS,
DOES NOT ACCEPT REMOTE CONTROL
COMMANDS
C A N N O T A D D A N E W R E M O T E
CONTROL
EACH TIME THE MOTOR IS POWERED IT
PERFORMS THREE BRIEF MOVEMENTS IN
BOTH DIRECTIONS
EACH TIME THE MOTOR RECEIVES A
COMMAND, IT MOVES BRIEFLY THREE
TIMES IN BOTH DIRECTIONS
RESETTING THE TRAVEL LIMIT (the remote controls stay memorised)

TROUBLESHOOTING

REASON
Already set travel limits
Sun sensor on
De-memorised
remote control
I n c o r r e c t
sending sequence
Non-memorised
remote control
Too many memorisable
remote controls (max 20)
The motor is in advanced
menu mode
The motor is in advanced
menu mode
7 seconds
P
x 1
Should you wish to change the travel limits, reset as
described in chapter 6, and teach again (chap. 5)
Perform memorisation of the first remote control
If there are no other remote controls, totally delete the
memory and follow the memorising procedure for the
If there are other working remote controls, perform the
procedure for adding remote controls and re-memorise
(see remote control instructions)
c o m m a n d Reset the travel limit to restore the motor's factory
(the remote controls will not be de-memorised)
Memorise the first remote control
Eliminate an old remote control and re-memorise the
Exit from the advanced menu, keeping the stop/preferred
position push-button pressed for 7 seconds
Exit from the advanced menu, keeping the stop/preferred
position push-button pressed for 7 seconds

X 1
RESET OK
SOLUTION
Turn off the sun sensor
single remote control.
settings.
new one