FAAC TM ER Serie Guia De Inicio Rapido página 8

2
THE MOTOR'S BUILT-IN RECEIVER CAN STORE UP TO A MAXIMUM OF 20 RADIO DEVICES (WALL REMOTE CONTROLS, RADIO WIND
GAUGES, ETC.). MEMORISATION CAN BE PERFORMED IN ANY MOTOR STATE.
1) DURING THE MEMORISING PHASE OF THE FIRST REMOTE CONTROL AND UP TO THE COMPLETION OF THE
TRAVEL LIMIT SETTING PROCEDURE, THE MOTOR IS MOVED USING THE DEAD-MAN SWITCH (KEY KEPT PRESSED)
2) BEFORE COMPLETING THE TRAVEL LIMIT SETTING, THE MOTOR COULD TURN IN THE DIRECTION OPPOSITE TO THE COMMAND
GIVEN (E.G. UP KEY PRESSED AND ROLLER SHUTTER GOES DOWN) ; AT THE END OF SET-UP , ENTIRELY AUTOMATICALLY, THERE WILL
BE CORRESPONDENCE BETWEEN THE UP OR DOWN KEY AND THE CORRECT SENSE OF ROTATION.
POWER ONLY THE MOTOR FOR WHICH YOU WISH TO MEMORISE THE REMOTE CONTROL
the motor will confirm with a brief movement in both directions

MEMORISE THE REMOTE CONTROL ON THE MOTOR
Press the P key for 2 seconds followed by the STOP/PREFERRED POSITION key
2 seconds

P
X 1
3
3.1
OR
MEMORISING THE FIRST RADIO
STEPS TO PERFORM
ON
WITHIN 10 SECONDS
SETTING THE ROLLER SHUTTER TRAVEL LIMIT
SETTING THE ROLLER SHUTTER TRAVEL LIMIT IN AUTOMATIC MODE
or ERO
CHECK WHICH KEY CONTROLS UP , AND KEEP IT PRESSED, WITHOUT RELEASING IT, UNTIL
THE MOTOR MOVES IN BOTH DIRECTIONS (END OF SET-UP)
UNTIL THE MOTOR CONFIRMS
2 seconds
X 1
+
KEEP PRESSED

MOTOR RESPONSE
X 1
X 2
X 1