Maintenance; Maintenance Schedule - Husqvarna LC 140 Manual De Usuario

Ocultar thumbs Ver también para LC 140:
Tabla de contenido

Publicidad

becomes yellow. A sharp blade also uses less
energy than a blunt blade.
Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
Introduction
WARNING: Before you do maintenance, you
must read and understand the safety
chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.

Maintenance

Do a general inspection
Examine the oil level
Clean the product
Examine the cutting equipment
Examine the cutting cover*
Examine the engine brake handle*
Examine and adjust the drive (clutch wire)
Examine the muffler*
Examine the spark plug
Change the oil (the first time after 5 h use, then after each 50 h use)
Change the air filter
Examine the fuel system
To do a general inspection
Make sure that all nuts and screws on the product
are tightened correctly.
To clean the product externally
Use a brush to remove leaves, grass and dirt.
Make sure that the air intake on the top of the engine
is not blocked.
Do not use a high pressure washer to clean the
product.
If you use water to clean the product, do not flush
water directly on the engine.
801 - 004 - 04.12.2019
level. If the grass is very long, drive slowly and cut 2
times if necessary.
Cut in different directions each time to prevent
stripes in the lawn.
Maintenance

Maintenance schedule

The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with * see instructions in
Safety devices on the product on page 8 .
To clean the inner surface of the cutting
cover
1. Empty the fuel tank.
2. Put the product on its side with the muffler down.
3. Hose down the inner surface of the cutting cover
with water.
Daily
Weekly
X
X
X
X
X
X
X
X
X
CAUTION: If the product is put with the
air filter down, the engine can become
damaged.
Monthly
X
X
X
11

Hide quick links:

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Lc 140s

Tabla de contenido