Battery Power - Chauvet DJ D-FI XLR PACK Guía De Referencia Rápida

EN
Operation
To set the D-Fi channel on the D-Fi XLR TX or the D-Fi XLR RX:
1. Set the power switch to the ON position.
2. Press the <MENU> button repeatedly to cycle through channels 1–16 (see diagram below).
LED Indicator Diagram

Battery Power

Each D-Fi XLR product comes with a rechargeable lithium-ion battery for cable-free operation.
The power indicator on the D-Fi XLR RX and the D-FI XLR TX shows red when the battery is charging,
and green when it is fully charged.
Do not charge the batteries in a closed container.
Battery Charge Notes
• Avoid depleting the battery below 10%.
• For best results, charge the battery in a temperature between 32 °F (0 °C), and 95 °F (35 °C).
• When charging the battery, keep the product at least 1 m from any open flame or hot plate.
• If the battery is completely discharged, the device cannot be turned on immediately when the charger is
connected. Allow a depleted battery to charge for a few minutes before turning on the device.
• While charging, the device may heat up. This is normal and should not affect the device's lifespan or performance.
If the battery gets hotter than usual, the charger may stop charging.
• Do not charge the batteries in a closed container.
• Do not charge the battery for more than 24 hours.
Battery Run Time
Product
D-Fi XLR TX
D-Fi XLR RX
3
QUICK REFERENCE GUIDE
Channel Signal
Channel Key
1 9
2 10
3 11
4 12
5 13
6 14
7 15
8 16
Maximum Run Time
Up to 11 hours
Up to 10 hours
Power
Recharge Time
4 hours
2.5 hours
D-Fi XLR Pack QRG Rev. 2