Music Playback Via Bluetooth - Silvercrest SKHK 40 C1 Instrucciones De Uso

NOTE
► The next time you turn on the headphones, they will automatically connect
to the last Bluetooth
®
Bluetooth
headphones, you will have to re-establish the connection manually. A de-
tailed description of how to do this can be found in the operating manual
for your Bluetooth
► If no Bluetooth
ends and the headphones switch off automatically.
► Ensure that the headphones are no more than 10 metres away from the
®
Bluetooth
electronic devices placed between them.
As soon as you connect the AUX IN socket
►
the Bluetooth
AUX IN mode . The Bluetooth
remove the audio cable

Music playback via Bluetooth

The following music playback functions are only available when the headphones
and the playback device are connected to each other via Bluetooth
NOTE
► It may be the case that not all functions will be supported depending on
the playback device used and its operating system.
Key
5
4
6
SKHK 40 C1
playback device that was connected. If your
®
playback device does not automatically reconnect to the
playback device.
®
connection can be made within 6 minutes, pairing mode
®
playback device. Make sure that there are no barriers or
function is deactivated and the headphones change to
®
®
e
from the AUX IN socket
► Press briefly to play/pause the music.
► Press briefly to increase the volume. When you reach
the maximum volume you will hear a beep.
► Press and hold to jump to the next track.
► Press briefly to decrease the volume. When you reach
the minimum volume,
you will hear a beep.
► Press and hold to jump back to start of the track. Press
and hold again within
2 seconds to jump to the previous track.
8
to the audio cable
function can only be reactivated once you
®
Function
e
,
8
.
.
®
GB │ IE │
11 ■