Chapter 2: English; Cable Requirements; Mounting A Wireless Lan Access Point On A Wall - Avaya WLAN 8100 Información Reglamentaria

Chapter 2: English

Using the following procedures and information when installing the Avaya AP 8120 access points.

Cable requirements

The Ethernet ports on the access point cannot accept a CAT-5 cable that has an uneven sheath
as shown below. The RJ-45 connector on the cable will not seat properly in the receptacle on
the access point. Use a CAT-5 cable with an even sheath instead.

Mounting a wireless LAN access point on a wall

The mounting bracket is designed to use wall anchors with threaded section diameters ranging
between 3.5mm and 4.5mm. If wall anchors have threaded diameters greater than 3.5mm,
only the two mounting holes marked 'A' may be used. If wall anchors have threaded diameters
of less than 3.5mm, the holes marked 'A' and the holes marked 'B' may be used. All wall
anchors must have a head diameter of less than 10mm or the wall mounting bracket cannot
be installed over them.
Perform the following procedure to mount a wireless LAN access point on a wall:
1. Locate the appropriate position of the wall anchors. The wall anchors should be
Avaya WLAN 8100 Regulatory Information - AP 8120
95mm apart horizontally and 80mm apart vertically.
December 20, 2010 13