Maintenance
(Heat engine version only)
Heat engine: see motor maintenance
manual.
Check oil level daily. See motor manual for oil change
and oil filter replacement intervals.
Use:
•
SAE 10W30 motor oil.
•
Use class API MS, SD, SE or higher for gasoline
(petrol) engines.
•
Use class API CD or CE for diesel engines.
Dispose of used lubricants
according to legislation in force.
To change oil, hold a funnel to oil drain outlet.
AIR FILTER:
•
See motor maintenance manual for servicing intervals.
For extremely dusty conditions, the filter element may
have to be cleaned up to three times a day.
•
Replace any damaged filters or packing seals.
General maintenance
•
Clean machine after each use
•
Frequently empty the pan to remove saw sludge that
may clog the water pump or wear it out prematurely
•
Swill out pan with water
•
Frequently clean the working areas of the head and
table castors
•
Periodically add bearing grease to guide castor
grease fittings (J) [FIG.5] and to disc shaft bearings
J
10 - English
MAINTENANCE
Oil level
(all versions)
[FIG.5]
Store products in a safe and secure
place, out of the reach of children.
Remove all setting tools and wrenches.
Store diamond tool where it will not
get warped or otherwise damaged.
Belt tension
After a certain amount of use, it may be necessary to re-
stretch the belt. (Do not over-stretch)
•
Loosen four screws (K) on motor [FIG. 6]
•
Turn tension screw (L) one quarter turn to pull back
the motor
•
When tension is normal, re-tighten four screws (K) on
motor
K
Never exceed original tension.
Important recommendations
•
Periodically re-tighten hardware, especially after first
hours of operation
•
Check belt tension but never over-tighten
•
When storing saw, remove disc and store carefully
•
Make sure that disc is kept wet by regularly
inspecting water injectors.
•
Tighten disc properly.
•
Keep disc, flange and shaft bearing surfaces clean.
The manufacturer declines any
liability resulting from any misuse,
modification or adaptation of the saw
or from use of a motor that does not
correspond to the manufacturer's
original specifications
L
[FIG.6]