Ce Identification Plate; Safety; Safety Definitions; Safety Instructions For Operation - Husqvarna CL400 Manual De Usuario

Dangers list label
Dangers list label is applied on the product.

Safety definitions

Warnings, cautions and notes are used to point out
specially important parts of the manual.
WARNING: Used if there is a risk of injury or
death for the operator or bystanders if the
instructions in the manual are not obeyed.
CAUTION: Used if there is a risk of damage
to the product, other materials or the
adjacent area if the instructions in the
manual are not obeyed.
Note: Used to give more information that is necessary in
a given situation.

General safety instructions

WARNING: Read the warning instructions
that follow before you use the product.
• Use the product with caution.
• Read the manual carefully before starting the
product.
• Obey the warning information on the safety labels.
Incorrect use of the product can cause damage.
• Keep your hands and feet away from the cutting
equipment.
• Before starting to work, make sure that there are no
objects on the ground. These objects can get ejected
by the product and cause injury to people nearby.
• Make sure that no people or animals come closer
than 20 m when the product is running.
• The operator must wear safety mask, overalls,
boots, protective gloves and cap.
• Do not perform maintenance on the product while
the engine is running.
4

CE IDENTIFICATION PLATE

Safety

• Do not modify safety devices.
• The operator is responsible if an accident occurs.
• If the product is used for an unapproved purpose,
the warranty will become invalid and liability will be
declined.
• Do not repair the product yourself. Speak to your
servicing dealer if there is a fault on the product.
• Always use original accessories.

Safety instructions for operation

Read the instructions that follow before you use the
product.
• Make sure that the cable on the cable laying guide is
intact.
• Make sure that the hose inside the guide is intact.
Replace the damaged hose.
• Make sure that there are no cuts along the entire
edge of the blade spout. Make sure that the edge is
not sharp or jagged. Replace the blade if it is
damaged.
1394 - 002 - 27.11.2019