Installation Instructions; Prepare Built-In Oven; Remove And Replace Oven Door(S) - Dacor DOB30P977 Serie Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation instructions

Prepare built-in oven

WARNING
Excessive Weight Hazard
Use two or more people to move and install an oven.
Failure to do so can result in back or other injury.
1.
Decide on the final location for the oven. Avoid drilling or cutting into house
wiring during installation.
2.
To avoid floor damage, set the oven on a cardboard prior to installation. Do
not use handle or any portion of the front frame for lifting.
3.
Remove the shipping materials and tape from the oven.
Remember to keep the packing materials that may be needed for installation.
4.
Remove the hardware package from inside of the bag containing literature.
5.
Remove racks and other parts from inside the oven.
6.
Move oven and cardboard close to the oven's final location.
Install_DOB30P977_DG68-01308A-00_EN+MES+CFR.indb 11

Remove and replace oven door(s)

IMPORTANT: Use two hands to remove oven door. For double ovens, repeat the
process for each door.
Prior to removing the oven door, prepare a surface where you will place it. This
surface should be flat and covered with a soft blanket, or use the corner posts
from your packaging material.
Disconnect LED light wire harness
Locate the LED light wire harness and disconnect it before removing the door.
Wire Harness
Single Oven
1.
2.
Double Oven
Carefully pull the wire to reveal the
connector.
Disconnect the connector.
English 11
2020-06-24
10:12:36

Publicidad

Tabla de contenido
loading

Tabla de contenido