Name Of Parts - Daikin FXMQ07PAVJU Manual Del Operario

3P338600_18B.book Page 3 Friday, December 13, 2013 7 03 PM

NAME OF PARTS

Refer to figure 1 on page [1]
1. Air outlet (Field supply)
2. Exhaust duct (Field supply)
3. Drain pipe
4. Connection piping
5. Transmission wiring
6. Remote controller (Field supply)
7. Drain discharge device (built-in)
Discharges indoor moisture removed during cooling
operation.
8. Power line
9. Ground wiring
This wire releases electricity from the indoor unit to
the ground in order to prevent electric shock or fire.
10. Air filter (inside filter chamber) (Field supply)
11. Suction filter chamber (Field supply)
12. Suction duct (Field supply)
13. Machine nameplate
The nameplate is imprinted with the machine name
and specifications.
14. Suction grille (Field supply)
MAINTENANCE
WARNING
• Only a qualified person is allowed to perform mainte-
nance without daily maintenance.
• Before touching any of connection wirings, be sure to
turn off all power supply switches.
• Do not use flammable materials (e.g., hairspray or insec-
ticide) near the product.
Do not clean the product with organic solvents such as
paint thinner.
The use of organic solvents may crack the product, or cause
electric shocks or fire.
• Contact professional personnel about attachment of
accessories and be sure to use only accessories speci-
fied by the manufacturer.
If a defect results from your own workmanship, it may result
in water leaks, electric shock, or fire.
CAUTION
• Before cleaning, be sure to stop unit operation, turn the
breaker off or remove the power cord.
Otherwise, an electric shock and injury may result.
• Do not wash the air conditioner with water, as this may
result in electric shocks or fire.
• Consult your dealer regarding cleaning the inside of the
air conditioner.
Improper cleaning may cause breakage of plastic parts, water
leakage, electric shocks and other damages.
• Watch your step at the time of air filter cleaning or
inspection.
Working is required in high areas, so extra caution must be
exercised.
If the scaffold is unstable, you may fall or topple down, thus
causing injury.
3
HOW TO CLEAN THE AIR FILTER
(The air filter is a field supply.)
Clean the air filter when the message Time to clean filter is dis-
played.
• This message is displayed once the unit has operated for a
certain amount of time.
• Always clean the air filter at the beginning of the heating or
cooling season.
Dust and dirt in the air filter reduce airflow, lowering the unit's
capacity.
• Clean the air filter more frequently when using the unit in an
environment with a higher content of pollution.
NOTES
• Do not remove the air filter for other than cleaning purposes.
Doing so may cause damage to the unit.
(The unit does not include an air filter as standard equip-
ment.)
• Do not install any object other than a proper air filter in the
suction inlet (for example, a paper towel). Doing so may
result in degraded performance and cause freezing or water
leakage.
1. Reset the filter message when the filter is cleaned or
replaced.
The Time to clean filter message turns OFF.
Refer to the operation manual provided with the Remote
controller for the positions of the Time to clean filter mes-
sage and how to reset the message.
HOW TO CLEAN AIR OUTLET AND OUTSIDE
PANELS (Field supply)
1. Clean with soft cloth.
2. When it is difficult to remove stains, use water or neu-
tral detergent.
NOTES
• Do not use gasoline, benzene, thinner, polishing powder, liq-
uid insecticide. It may cause discoloring or warping.
• Do not let the indoor unit get wet. It may cause an electric
shock or a fire.
• Do not use hot water of 122°F or higher, as doing so may
result in discoloration or deformation.
English