4 Preparation
4
Preparation
4.1
Preparing the installation site
WARNING
The appliance shall be stored in a room without
continuously operating ignition sources (example: open
flames, an operating gas appliance or an operating electric
heater).
4.1.1
Installation site requirements of the
indoor unit
INFORMATION
The sound pressure level is less than 70 dBA.
▪ Air flow. Make sure nothing blocks the air flow.
▪ Drainage. Make sure condensation water can be evacuated
properly.
▪ Wall insulation. When conditions in the wall exceed 30°C and a
relative humidity of 80%, or when fresh air is inducted into the
wall, then additional insulation is required (minimum 10 mm
thickness, polyethylene foam).
▪ Wall strength. Check whether the wall or the floor is strong
enough to support the weight of the unit. If there is a risk, reinforce
the wall or the floor before installing the unit.
▪ Spacing. Install the unit at least 1.8 m from the floor and keep the
following requirements in mind for distances from the walls and
the ceiling:
≥50
5
Installation
5.1
Opening the indoor unit
5.1.1
To remove the front panel
1 Hold the front panel by the panel tabs on both sides and open
it.
a
Panel tabs
2 Remove the front panel by sliding it to the left or the right and
pulling it toward you.
Result: The front panel shaft on 1 side will be disconnected.
3 Disconnect the front panel shaft on the other side in the same
manner.
Installation manual
4
5.1.2
1 Attach the front panel. Align the shafts with the slots and push
2 Close the front panel slowly; press at both sides and at the
5.1.3
1 Remove 1 screw from the service cover.
2 Pull out the service cover horizontally away from the unit.
5.1.4
≥50
1 Remove the front panel to remove the air filter.
(mm)
2 Remove 2 screws (class 15~42) or 3 screws (class 50~71) from
3 Push down the 3 upper hooks marked with a symbol with 3
a
a
4 We recommend opening the flap before removing the front
5 Place both hands under the centre of the front grille, push it up
a
a
Front panel shaft
To re-install the front panel
them all the way in.
centre.
To open the service cover
a
Service cover screw
b
Service cover
To remove the front grille
CAUTION
Wear adequate personal protective equipment (protective
gloves, safety glasses,...) when installing, maintaining or
servicing the system.
the front grille.
circles.
b
a
Upper hook
b
Symbol with 3 circles
grille.
and then toward you.
CTXM15+ATXM20~50+FTXM20~71N2V1B
a
b
a
Daikin room air conditioner
3P482320-8K – 2018.09